Polymer 80 Rails Not Lining Up, But I have noticed a slight wear spot on the front of my front rails.

Polymer 80 Rails Not Lining Up, Also, I polished the rails You gotta get the top of the rails to line ups with the top of the polymer tab right behind them. If you notice, the distance the rails need to drop is also the Its actually pretty common for the rails to not line up perfectly. PF940C rear rails not lining up (pictures in comments) Hey guys I've been having trouble finishing my PF940C build. The problem is that the rear rails do not line up, specifically the right side of the rear Rear rail on PF940c did not line up with pin hole? So apparently I am not the only person who experienced this issue. After troubleshooting hundreds of P80 builds in our shop and helping customers diagnose We help you fix every Polymer 80 Slide Issue from your slide won't come off, to slides not racking, and even failure to return to battery. I try to tell them that the When you please a straight edge on these rails, there is a severe “downslope” towards the rear rails, and they don’t line up with them. Answer is usually to sand down on the curved face so that the rails sit further down in the frame. All the pins in my p80 need to be tapped out with a punch and hammer, no pushing is possible. If I remove the pin and install the trigger it pushes up the rail. The slide fits but if I People are going to yell at me for this, but after I shave the rear rail down a bit and verify there are no additional burrs I will heat up the bottom of the locking block and kind of melt it down into its position. ukbghq kk ioxz fuqndgp 6fukl 99z36 gkhccl okp tgsve roreb